The page index categorises the build diary pages by topic - so if you want to find the day
relating to fitting the seats, just click the relevant link.

Page	Jobs
1	Kit parts, wing to fuselage fitting, flap trailing edge
2/3	Acetone, new tools, seat frames, noseleg and main gear, control sticks, flap leading edges
4	First fit door lexan, assembling tail plane, routing rudder cables, cutting out flooring
5	Trim tab piano hinge, fitting I beams, more tail plane, more floors
6	Flap trailing edges part two, aligning hinge plates
7	Fitting seats to fuselage, seat anchor brackets
8	Wheels & tyres, side & top stringers, control pulleys, seat harnesses
9	Swage tool, main gear bungees, flap lever assembly, sliding in I beams, main spar bracket
10/11	Mair spar bracket again, wing trailing edges
12	Wing trailing edge slots, seats and harnesses
13	Cutting and fitting instrument panel, rough trimming the door lexan
14/15	Fitting and rivetting lap & aileron hinges
16	A clinometer, flap leading edges, flap & aileron false ribs
17	Tail plane - aligning and assembly
18	Fixing the tail plane, flying wires, cutting door lexan to fit
19	Flap/aileron cut-outs and pulleys, rivetting hinge plates, setting the trim tab
20	Fitting wheels, rudder pedals, fabric templates and static/pitot tubes
21	Rectifying a mistake - un-gluing a flap and aileron
22	Wing gussets, root doublers, butt ribs
23	Flap/aileron pulleys and blocks, jury struts
24	Control cables, flap/aileron leading edge cut-outs
25	Wing false ribs, fuel tank preparation, fitting the first fabric plate
26	Wing tips
27	First fix of strobes, Microstop countersink tool
28	Strobe cables, fitting fabric plates, control stick handles
29	Bottom stringer, rear access plate, wing tip braces
30	Aircraft Covering supplies, CAA registration, Superfil filling
31	Pitot and static tubing, Final cutting of door lexan, gluing the wing tip
32	Fitting fuel tanks, rear floor panel, push rod cover, cutting turtle deck lexan, calibrating an iron
33	Covering an elevator
34	Taping, polybrush, instrument panel mock-up
35	Cutting the turtle deck, fitting the headertank
36	Covering a wing
37	Setting up a spray booth, spraying the engine mount
38	Spraying polybrush, fitting bootcowl and firewall rubber, cutting holes for the noseleg
39	Spraying silver, fitting buttribs
40	Brake pedals and cylinders
41	Fitting the windscreen
42	Battery tray, header tank and drain system
43	Fuselage jig and covering the fuselage
44	Taping the fuselage
45	Cable fairings, panel layout, more fuselage
46	Silver spraying, registration stencil
47	A painted fuselage!
48	Painting the panel, trim tab fitting, protective tape
49	Painting the wing registration letters
50	Turtledeck finishing, radio whip, window striker plate, door pin